IC-RC IR Remote

Installation

IR Code Programming

The IC-RC sends high- or low-frequency Contemporary Research IR codes, as well as IR codes for Philips, RCA and Zenith.

To change the IR code format, just press and hold the Select button and the numeric key below, then release the buttons together For example, to select low-frequency CR code transmission, hold down Select and the 4 key.

1 = Zenith Smart TV - 38 KHz
2 = Philips Smart TV - 38 KHz
3 = RCA Smart TV - 57 KHz
4 = Contemporary Research - 38 KHz
9 = Contemporary Research - 57 KHz (default)

Newer iC-series controllers and IR-RXC external IR receivers sense IR at 57 KHz (default) or 38 KHz. Some older units and the IR-RX only receive IR at 38 KHz. Make sure IR settings on controller and external receiver match the IR Code format settings on the IR-RC remote.

For complete information regarding IC-RC IR code programming, and using the IC-RC for on-screen setup of many iC-series tuners and controllers, see the IC-RC Installer Reference Guide.

© 2008 Contemporary Research Corporation. All rights reserved.