ICC-ZS2 LG/Zenith SuperPort Card

Installation

1. Turn off TV.
2. Zenith TVs have 2 card spaces. If there is a blank plate, don’t use that space for the iC-Net card. Replace the existing card that has the F connector with the Zenith SuperPort card.
3. Remove existing card, removing internal Ground and RF wires if attached.
   Pull out card partially, then disconnect wires before completely removing.
4. Connect internal Ground and RF wires to ZS2 card.
5. Insert ZS2 card into SuperPort.
6. Turn on TV.
7. The Net LED should light and stay on, indicating power, but not iC-Net communication.
8. Com LED turns on when data link with TV is established, blinks when data sent from IR remote, front-panel buttons, or iC-Net commands.

SmartPort – New Digital TVs
For TVs with ATSC tuners, the ICC-ZS2 card must be installed in the ANTENNA/CABLE slot. DO NOT install the ICC-ZS2 card in the DIGITAL/ANTENNA card slot as this may damage the TV. This applies to series H27H38DT/H32H38DT and similar TVs.

Zenith ScanCard DIP Switch
We have included a 4-position DIP switch that enables ScanCard compatibility with older Zenith TVs.

1. All four DIP switches are set to the OFF position from the factory – this is the normal setting for new TVs and older models without ScanCards.
2. If you are installing the ICC-ZS2 in an existing TV that has a ScanCard, turn all four switches ON.
3. If the switches are set ON in a new TV, you will likely hear electronic noise in the audi o.

© 2012 Contemporary Research Corporation.
Contemporary Research® is a registered trademark of Contemporary Research Corporation. All rights reserved.