FT1-3 Closure Panels

Installation

Wiring

Pin 1 Chassis GND is connected to the metal bezel and should be tied to earth or airframe GND, or left unconnected.

Pin 1: Chassis GND
  Pin 2: Switch 1 output
  Pin 3: Switch 1 input for LED Feedback
  Pin 4: Switch 2 output
  Pin 5: GND
  Pin 6: PWR (+5 VDC)
  Pin 7: Switch 2 input for LED Feedback
  Pin 8: Switch 3 output
  Pin 9: Switch 3 input for LED Feedback

Mounting

The FT1-3 panels are designed for precision snap-fit installation into wood, plastic, and metal surfaces. Routing should be based on the actual enclosure, not ACAD drawings alone.

 FT1 Cut-Out: - 2.06" wide x 1.07" high
 FT2 Cut-Out: - 2.06" wide x 1.07" high
 FT3 Cut-Out: - 2.88" wide x 1.07" high

© 2010 Contemporary Research Corporation.
Contemporary Research® is a registered trademark of Contemporary Research Corporation. All rights reserved.